What are the matters needing attention in the application of high pressure steel wire wound hose?
There are many types of high-pressure steel wire wound rubber hoses in the sales market. When you choose, you can choose according to your own development trend. In the application, you can understand
What are the matters needing attention in the application of high pressure steel wire wound hose?
There are many types of high-pressure steel wire wound rubber hoses in the sales market. When you choose, you can choose according to your own development trend. In the application, you can understand the matters needing attention of high-pressure stainless steel wire wound rubber hoses.
High pressure wire wound hose in the application of the need to pay attention to the important matters are the following:
1. The bending radius of the high-pressure steel wire winding hose shall not be less than the given bending radius to prevent damage to the rubber hose structure or early damage due to too much flexion and extension.
2, in the application, in the selection of the production of high-pressure wire winding hose should be based on the use of specifications, appropriate selection of rubber hose type, specifications and technical parameters, do not misuse or replace.
3. In the application of high-pressure steel wire winding hose, the pressure should be balanced and adjusted to avoid sudden pressure expansion and damage to the tube body.
4. If the detailed address of the work changes, the high-pressure steel wire winding hose shall be transported to the ground first, and the ground shall not be mopped as much as possible to prevent corrosion of the frame layer after scratching the outer rubber.
5. When transporting corrosive liquid, the internal structure of the rubber hose should be cleaned and tidy after use to prevent residue from remaining and corroding the pipe body for a long time. Matching product types can also be used.
Application of high pressure steel wire winding hose:
(1) Before use, check whether the product specifications and length meet the specified requirements, and conduct a pressure test during sampling work, and then use it after passing the test.
(2) Check whether there is exposed stainless steel wire at the joint of tee joint and rubber hose, and whether the external adhesive shows mineral pressure. Industrial dryers cannot be used if there is such a situation.
(3) The coating at the butt joint of the top of the tee joint shall not be damaged or exposed, showing that exposure cannot be used, so as to avoid liquid leakage caused by too loose tightness.
(4) The inner wall of the plastic hose treatment pipe of the new equipment shall be removed to prevent the glue and dirt from entering the four-column hydraulic press management mode.
Equipment requirements for high-pressure steel wire winding hose:
(1) The plastic hose shall be prevented from changing during the docking, so as to avoid the initial damage due to the change of the focusing point of the frame layer.
(2) After docking, the length of the plastic hose should be vacated to a certain volume to avoid the change of the length of the plastic hose caused by the tensile effect and reduce the compressive professional ability.
(3) The fixed iron clamp of the plastic hose should be placed on the straight line of the intersection point of the trend chart and the straight line. The iron clamp cannot bend the plastic hose or loosen it too much.
(4) When docking prefabricated components for exercise and fitness, the length should be set up to avoid injury to plastic hoses during exercise and fitness.
(5) The hardships of docking shall conform to the relevant provisions of the relevant requirements.
High-pressure steel wire wound hose is widely used in hydraulic support, and the amount of each fixed support is about 10-30. Therefore, the structure, application method and docking method of high-pressure hose will also damage the stability of fixed support immediately.